Electric Remote Control Venetian Blind - 遙控電動百頁簾

 

SPECIFICATION

  1. Group A buttons are the buttons of moving up, down and stop.
    ‧ is a button of moving up and stop
    ‧ is a button of moving down and stop
  2. Group B buttons are the buttons of swinging left, right and stop.
    ‧  is a button of swinging left and stop
    ‧   is a button of swinging right and stop
  3. is a button of setting for the blind moving to the downward limited and upward limited position.
  4. is a button of setting the strength for the slats of the blind swinging leftward limited and rightward limited position.
  5. The setting of downward limited and upward limited position. (Please point the remote controller to the venetian blind)
    ‧ You  MUST set the     downward position first
    ‧ Press button for 6 seconds till the red light flush and release the button
    ‧ Press button, the blind will go down till to the desired position and press the same button again to stop the blind. Press  button to confirm the downward limited position.
    ‧ Press button, the blind will go up till to the desired position and press the same button again to stop the blind. Press button to confirm the upward limited position. The red light will change to green light and stop to flush.
  6. Strength setting for swinging left and right
    ‧ Press button for 6 seconds till the red light flush and release the button
    ‧ Press  button to add the strength of the motor
    ‧ Press button to reduce the strength of the motor
    ‧ Press or  of the button 50 times to the maximum or minimum point. To the end, there will be a sound     Di-Di-Di  . When the right strength is derivet, press the to confirm that.
    ‧ In general situation the above setting is already presetted by the factory.
  7. Notice of setting
    ‧ Do not let the blind going to the extreme point of downward limited and upward limited position. There is always a deviation of exact position.
    ‧ If necessary, set the strength of the motor to minimum point and increase time by time when strength setting for swinging left and right. Follows this procedure will be avoided the damage of motor and accessories.